Thread: Pandaboard will not boot - problem with / and /tmp
i followed these instructions:
found https://wiki.ubuntu.com/arm/omapdesktopinstalllinux
steps:
place sd card @ host computer.
make sure sd card not mounted (just umount if needed)
identify correct raw device name (like /dev/sde - not /dev/sde1)
run following command write it:
(replacing omap4 , sde right values i.e. omap beagle image.)
zcat ./ubuntu-12.04-preinstalled-desktop-armhf+omap4.img.gz |sudo dd bs=4m of=/dev/sde ; sudo sync
looks going ok, message comes saying card being resized, goes down reboot , when comes following message:
for example if press "s" skip error message reads:errors found while checking disk drive /
press f attempt fix errors, ignore, s skip mounting, or m manual recovery
if don't few minutes console screen says:the disk drive /tmp not ready yet or not present
i don't know login fore this.ubuntu 12.04 lts localhost.localdomain tty1
localhost login:
can manual recovery there have no idea i'm not sure going on. since i'm using pre built image thought work?
ideas on this?
a little bump little
Forum The Ubuntu Forum Community Ubuntu Official Flavours Support General Help [ubuntu] Pandaboard will not boot - problem with / and /tmp
Ubuntu
Comments
Post a Comment